Enhanced Flash Memory Lifetime with DIE-RAID

As the physical size of NAND flash cells reduces, more cells are accommodated per unit area, increasing storage capacity. However, this may lead to higher interference with the charge trapped in the cell, resulting in a larger error bit rate. Each cell can hold more bits, which means the buffer between voltage levels decreases and read errors become more likely. Without countermeasures, this leads to failures in modern NAND flashes after a short time. Error correction is therefore one of the most important functions in memory products.

Due to its effectiveness, BCH code (Bose Chaudhuri Hocquenghem code) has been a commonly used error correction method in NAND flash. With recent technological advancements, this method is being replaced by Low-Density Parity Check (LDPC) as the standard ECC (Error Correcting Code) function for most SSDs. It has a stronger error correction capability compared to the BCH code, providing a more precise identification of the original bit sequence after an error.

DIE-RAID is another crucial tool for correcting erroneous bits. Its drawback is that SSDs appear to have capacities below the standard Power-of-Two table. This seemingly missing use capacity is in fact storing parity data, which is used to correct error bits when ECC fails to do so. Combined with other error correction features, DIE-RAID increases the number of program/erase (P/E) cycles and ensures consistent flash performance over time.

Redundant Array of Independent Drives (RAID) uses mirroring, striping, and parity data storage to ensure data integrity when using two or more storage drives. Mirroring copies of data from one drive to another ensures that a set of data is available in the event of a drive fail (RAID 1). Striping describes how data sets are written to the different drives, as opposed to being stored on a single drive.  Parity data is used in configurations with three or more drives, each storing a section of the distributed parity data in case any of the remaining drives fail (RAID 5).

DIE-RAID error correction method follows the same principle as standard RAID for storage drives in RAID 5. Instead of spreading the data across the drives, DIE-RAID spreads the data across different die, adding a parity buffer to each set. The RAID engine, located in the controller, decides how to store the data received from the SSD. The engine constructs the RAID stripes and also performs RAID recovery when error bits are detected and other ECC functions could not fix the problem. Once the command to read data is sent, it first goes through the LDPC engine. Whether the data is correct or one or more error bits have been corrected by the LDPC engine, the data is read without any problems. If the LDPC engine is unable to correct the error bit, the RAID engine performs a RAID rebuild to correct the error. It will mark the block as faulty if it fails to correct it. This means that DIE-RAID acts as an extra layer against error bits and ultimately increases the lifespan of any SSD.

For DIE-RAID, a part of the capacity of the SSD must be reserved for error correction. However, especially in the industrial sector, DIE-RAID contributes significantly increasing the lifetime and ensuring higher data integrity. With DIE-RAID, the start of the read repetition can be delayed due to the additional decision level in determining the bit values. This means an increase in data integrity and a more stable device lifetime. It is suitable for all applications that have a high data throughput and ensures there that the SSD can provide continuous performance over the long term.

Über Innodisk Europe B.V.

As the physical size of NAND flash cells reduces, more cells are accommodated per unit area, increasing storage capacity. However, this may lead to higher interference with the charge trapped in the cell, resulting in a larger error bit rate. Each cell can hold more bits, which means the buffer between voltage levels decreases and read errors become more likely. Without countermeasures, this leads to failures in modern NAND flashes after a short time. Error correction is therefore one of the most important functions in memory products. LDPC is currently the standard ECC function for most SSDs. With it, a very precise identification of the original bit sequence after an error is possible. Die RAID is another important tool for correcting error bits. If the so-called LDPC engine is not able to correct the error bit, the Die RAID engine performs a RAID recovery to fix the error. If this is not possible, it marks the block as faulty. RAID acts as an additional layer against error bits and increases the lifetime of SSDs. It is suitable for all applications that have a high data throughput and ensures there that the SSD can provide continuous performance in the long run.
#Innodisk #NAND #Flash #ECC #DieRAID

Firmenkontakt und Herausgeber der Meldung:

Innodisk Europe B.V.
Pisanostraat 57
NL5623CB Eindhoven
Telefon: +49 (152) 5100 6027
http://www.innodisk.com/

Ansprechpartner:
Patrik Stocks
Innodisk Europe B.V.
Telefon: +49 (152) 5100-6027
E-Mail: Patrik_stocks@innodisk.com
Edgar Huber
Marcom360
Telefon: +49 (7083) 933745
E-Mail: edgar.huber@marcom360.de
Für die oben stehende Pressemitteilung ist allein der jeweils angegebene Herausgeber (siehe Firmenkontakt oben) verantwortlich. Dieser ist in der Regel auch Urheber des Pressetextes, sowie der angehängten Bild-, Ton-, Video-, Medien- und Informationsmaterialien. Die United News Network GmbH übernimmt keine Haftung für die Korrektheit oder Vollständigkeit der dargestellten Meldung. Auch bei Übertragungsfehlern oder anderen Störungen haftet sie nur im Fall von Vorsatz oder grober Fahrlässigkeit. Die Nutzung von hier archivierten Informationen zur Eigeninformation und redaktionellen Weiterverarbeitung ist in der Regel kostenfrei. Bitte klären Sie vor einer Weiterverwendung urheberrechtliche Fragen mit dem angegebenen Herausgeber. Eine systematische Speicherung dieser Daten sowie die Verwendung auch von Teilen dieses Datenbankwerks sind nur mit schriftlicher Genehmigung durch die United News Network GmbH gestattet.

counterpixel